Orders Shipping Now!

How to Install the Anytime Backup Camera Harness (ABC-28)

Below are a few tips on how to install the Anytime Backup Camera Harness (ABC-28) for viewing of your factory backup camera at any time.
Anytime Backup Camera Harness (ABC-28)
You will receive the harness above which has 28 wires in the harness with two wires in a sheath coming off the female end of the harness.  The harness will plug into the rear of your factory in dash screen in the place of the existing 28 wire harness and then the factory 28 wire harness will plug into the other end of the Anytime Backup Camera Harness (ABC-28).
Harness (ABC-28) Plugged into the rear of the In-Dash Screen
Anytime Backup Camera Harness (ABC-28) - Wire Functions
The two wires will be connected directly to the switch to control the harness.  We recommend using our switch (ABC-FRS pictured below) but you can also use any SPST (Single Pole Single Throw) switch of your liking.
The RED wire from the Anytime Backup Camera harness (ABC-28) supplies 12v to the system and should be connected to the RED wire on our switch (ABC-FRS).
Next the ORANGE wire on the Anytime Backup Camera harness (ABC-28) is the load and should be connected to the ORANGE wire on our switch (ABC-FRS)
Front and Rear Camera Switch (ABC-FRS)
Wire Functions
BLACK -      Chassis Ground
RED -           12v Supply (RED wire from Override Harness ABC-28)
ORANGE -   Rear Camera (ORANGE wire from Override Harness ABC-28)
GREEN -      Front Camera (GREEN wire from Switching Relay ABC-RELAY)
GRAY -         NOT USED
BLUE -         NOT USED